Sparco 600 Seat Bracket - Mazda MX-5 Miata (NB, 1998-2005) - Driver/Left

• Fits 1998-2005 Mazda MX-5 Miata (NB), driver/left side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Sold individually. The passenger side is 600SB109R
• Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

A 1998-2005 Mazda MX-5 Miata is built to be driven hard, and the factory seat is usually the first thing that stops keeping up. Once the tires, brakes and suspension are sorted, you start sliding around in the stock seat mid-corner. A proper bucket fixes that, and it needs a solid base underneath it.

Sparco 600 Series seat bases pick up the factory seat mounts on the vehicle's floor and give your seat a flat, rigid mounting surface. Each base is vehicle-specific and a 100% bolt-in installation, so there's no cutting, welding or drilling into the floor.

It's built from 3/16" steel for stiffness and finished in black wrinkle powder coat. The Sparco top plate is drilled for Sparco sliders. There's also a wide platform for direct side-mount installation (drilling required), which drops the seat as low as possible in a race car.

This is the driver/left base, sold individually. The passenger side is 600SB109R. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.